Search results

I had an instance of a van leaving the washbay before the wash ended and the van caused some damage. The Gantry was at the front of the van at start of wash, and the van pulled forward, out of the wash area. the Gantry continued to tavel to the rear, and stopped cuz no vehicle detected. The...

So here we go again :)...i do enjoy learning and fixing these problem. So the OHD faults on the passenger side front of the car at the initiation of PASS 1. I am sure it is a sensor or proxy...so I attached a video of the IO panel....any help my friends...

Hello all...another fun one with the Ryko 2001 OHD overhead unit. received a customer call the wash went down, the gantry is stuck near the rear of the vehicle. I turn the unit to "Closed" to try to 'Home' the system. The gantry will only move in the rear direction, and there is less than a...

I am having an issue...When the doors open for normal operation...they get about 80% open, then close automatically and repeat this until the car either goes thru or backs off the sensor. I can override with the E-stop and the doors completely open. I had a relay timer go bad (the OMRON H3cA)...

I froze up my system and have been throwing money and chasing problems for over a month...I f I cant fix this one, I may be out of business... I installed a new booster pump and I cannot get it to flow. There was a burned our valve Y7 which is the RO inlet valve. I replaced that (208v solenoid...

I keep getting this "07" VFD fault. It happens at 2 instances...when the OHD gantry approaches the car at start of wash...ganty moves forward to front of car, pauses, and then "Wash Complete" "Thank you for Your Business" comes up on the display in the wash bay, and there is a code 07. The other...