Search results

Good Morning all, I have a foam brush not working in one of my bays. Here's what I've done so far: When the feature is selected in the bay I have 24v in the control box(where motor starter is) on wire terminal for the foam brush. However, the solenoid was not opening. I put a new solenoid on...

Hey all So I’ve managed to figure out most of my Carwash and what stuff does. But for the life of me I can’t figure out what the blue line is for that I circled in the picture. each pump has it. The hose comes from a manifold that comes off the main water line. Turning the valve on each hose...

Hey guys, I have 4 cat 310 pumps. All are working fine. However the prior owner of the wash has no idea when the seals and valves have been replaced. I noticed some the seals look bad and I pulled the valve on one pump and it seen better days. I figured I’d service all the pumps. But my...

Hi guys, Looking for some advice. I purchased a led6 timer for my bay. I have a ginsan sensortron 57475 gs-41 coin acceptor. My issue is it does not recognize coin input. I have it wired the following way: The sensortron has a yellow, blue and gray(possibly black but faded) wire harness Gray...

Hi all, I recently purchased a four bay carwash in Louisiana. We have a freeze coming next week and looking for some tips. my plan is to shut off the main put a space heater in the pump room and drain my hydrominers. My setup does not have a weep mixer but my guns are weeping guns. My concern...