Search results

Is the Tbar impact sensor working. It is also on X32.

You could have the bottom 4 inches of the lower arches and lower arch cover cutoff so that it will fit. It should only remove 1 nozzle from each of the two arches

Have you checked the Encoder prox?

This might work. The head is 3.25 inches but is polypropylene so it might compress enough to get into and out of the opening in a 5 gallon container.

The roller shafts are different for bearing rollers versus greased rollers. Since you have a freestanding dryer I would recommend staying with the greased rollers. They are easier to change. The only advantage to the bearing rollers is that you don't have to grease them, but the bearings can...

You can replace all the rollers with the ones PDQ used on it's docking dryers. They require a different shaft and two bearings per roller but do not need to be greased. The tire bearings would simply need to be replaced with sealed grease less bearings with the same specs. While this would...

If you are just using single barb injectors then I like the Dema better. It can be rebuilt and holds up really well. If you are using dual barb injectors then the hydraflex are easier to install and get the soap lines on.

They just created some new products last year for touchless that I have had good success with. I'm using HP-640 low pH for the first pass, and AL-10 high pH with ALTP-1200A for the boost on the second pass. It needs a 10 to 15 second dwell after each application on a Laserwash.

Pin 2 on the J2 connector for the VT card. It's the upper right hand terminal and should be labeled output.

We grease ours monthly and are getting almost twice the life out of them.

Sorry that was a typo, it should be 63356#

Type in 66356#. Select run diagnostics and select X10 input card. The display will show each of the 8 inputs with either a 0 or a 1. 0's the A-5000 sees as off. 1's are seen as on. If it's seeing the correct inputs as being on and off then the LED's don't matter. They just make it easier for you...

Ceramic is best applied with low pressure. Higher pressure can cause some of the ceramic to bounce off the car, requiring more ceramic to create an even coat. Plus high pressure uses more water requiring additional product to achieve the correct titration. That said, I agree with Wash shine...

BRAAS is a distributor for Wago. There website is at braasco.com.

Marco Marinelli is my JBS rep, and he has been excellent to work with.

I haven't ever worked with Blendco, but the mixing drum should allow for a lot of control of your high pH. The JBS is harder to tweak. If you decide to try the JBS, I like the Action line for regular road film and bugs. I use AT-101 Low pH for my first pass, and AT-102 High pH and AT-150 High...

Correct, 0424006 only works when it sees a signal from 0424005. You are probably going to have to reach out to PDQ to get a replacement.

I forgot the new style is also cheaper. Unless the bridge is stopping too soon and the T bars are blocking the backup eyes or you are getting sun light directly on the VT eyes, you are on the right track with it being a bad eye. If this was a retrofit, then you might also want to make sure the...

I don't know what brand they were. They are the old style. PDQ switched to Banner Eyes when they redesigned the VT. They are part number 4070003 for the receiver and 4070004 for the transmitter. The banner eyes can be wired to one of four different frequencies and are quick disconnect. You...

0424006 is the receiver for frequency B, while 0424004 is the receiver for frequency A. They are different frequencies to prevent cross talk. They are not interchangeable.