Search results

It`s late Sunday evening and I`ve just recently found out my Laserwind dryer is not coming on. I did a quick check to see if any breakers were tripped and I didn`t find anything. When I test it the nozzels will move but the dryer doesn`t start. Also the relays in the electrical panel on the...

Tri-foam hanging on the tee bar can cause this also. Do you have the little shields on the tee bar that protects the eyes from this?

Mustang is right, Fragramatics will loan you one. Call and ask for Kelly.

Are these Dixmor timers? If so you can buy just the red case from Kleenrite. Be sure to get the protective piece of plexiglass. Even if they identify the kids, restitution could take a while.

I`ve been in this business about 30 years and have never had a pump to fail in the crankcase. I have never bought Cat oil. I have always used Chevron ISOGST100 Turbnine Oil. It is designed for industrial turbines and marine applications. Cost $50 for a five gallon pail. I would never change...

For starters you need to reveal what part of the country you are in. There are a lot of good cleaning products out there and a whole lot of opinions here on the forum. One thing I might add is I like my presoak heated.

Remove the tube and cut about a half inch off and then reinsert it. Sometimes the tube will tend to get out of shape where the collet is holding it in. It may not look like it to the naked eye. Push in real hard then try to pull it out. It it if caught properly, you can`t.

Paul, It`s the same size hose as those on my IBA that feeds the injectors. I`ve had it both ways and the smaller hose is much easier to deal with. Think about the size hole that`s in the tip. The quarter inch hose has plenty of volume. Try it,you might like it. I`ve had these in three washes for...

I changed over from the 1/2 hose to 1/4 on the chemical side of the hydrominder a long time ago. You can get the smaller tips and the piece they fit into into from any of the car wash suppliers. Works much better. I would never change back to 1/2 inch.

If you are picking up air it will pulsate also. Tighten all the lines that lead to the pump, soap, wax, inlet water.

David how were you able to determine he was doing this? I know you said there were scratches. Have you tried a magnet?

If you are cleaning your walls with New Wall, make sure you don`t get it on the meter and into the shaft of switch.

Is this isolated to Ginsan or will it work on other acceptors?

Mark, send me an e-mail. I can help.

Mac you always seem to be on top of everything but have you thought about it being condensation building up inside the pump.

One thing I noticed about them are they are really heavy.

I`m not an electrician either but what`s wrong with this. Replace the breaker with a 20 amp double pole. Keep the wire but go to each light and rewire the ballast to the 220 side. Assuming they are multi-tap ballast.

Sequoia, when you put the gallon of methonal in five gallons of soap which tip do you use?