Part identification help

T

trinityspeedwash

Member

• Aug 14, 2025

• #1

Looking for help to identify a part that is used to fill the soap in a Coleman assembly.

In the picture is the "float switch" that fills the tank, and splices in the soap. It is akin to the toilet bowl filler at my house.

I believe I need to replace it since the pressure coming out of it is low; however, I cannot find this assembly at my local Kleenrite.

Thanks as always.

 

Attachments

• 
  Screenshot 2025-08-14 062625.jpg

  108.4 KB · Views: 36

Rfreeman

Well-known member

• Aug 14, 2025

• #2

That's a hydrominder.

Start by making sure the screen is clean and not clogged up restricting flow.

You will need to shut water supply off before.

 

T

trinityspeedwash

Member

• Aug 16, 2025

• #3

Awesome. Thank you. I ended up purchasing a new/replacement kit. I looked at the screen and it was not clogged.

Back up and running!

 

R

Randy

Well-known member

• Aug 16, 2025

• #4

I hope this is the repair kit you bought

Hydro Systems 6655-P | Hydrominder Replacement Valve Parts Kit | Kleen-Rite

This valve kit replaces the parts in your HydroMinder valve that are prone to wear and tear over time. Fits models 506, 507, 511,530, and 545.

www.kleen-ritecorp.com

Is you get the plastic stem reuse the brass stem, they are a better stem. We keep a few of the rubber diaphragms KR#IN665500

 

G

Greg Pack

Wash Weenie

• Aug 17, 2025

• #5

The rubber diaphram is a $3 part and between that and cleaning the inlet screen that solves 90% of your problems with those.

 

R

Rudy

Active member

• Aug 17, 2025

• #6

Sometimes, the eductor can crack allowing the system to suck air instead of product. Again, just keep a spare or two on hand.

Keep a spare:
Eductor
Stem
Diaphragm

That'll cover most anything......