Menu
What's new
By:
Filters

Looking for a rail stand for a PDQ 360+

Monte

Monte

Member
Joined
Apr 30, 2020
Messages
88
Reaction score
47
Points
18
I have purchased a used 360+ that has wall-mount hardware for the rails. Does anyone have a stand, in any condition, they would sell that would work?? or trade me for the wall mount hardware??

PDQ wants a ridiculous amount of money for a NEW SS stand. I have 2 other 360+'s that are operating on, I assume, the earlier generation galvanized stand...I am also wondering if anyone has mounted PDQ rails on a WW stand or competitors stand???

FYI...I prefer wall mounting, but at this site, the bay width is too much. Or has anyone built or fabricated brackets for a wide bay application.
Your comments or advice on the project, will be appreciated.
Thanks
 
K

Keno

Well-known member
Joined
May 30, 2022
Messages
544
Reaction score
274
Points
63
Might be worth having a local fabricator/welder or 2 come out to see what they would charge to build your stand or brackets.
 
Monte

Monte

Member
Joined
Apr 30, 2020
Messages
88
Reaction score
47
Points
18
I will have to get back with that number. We are removing McNeil short tunnel and replacing with pdq 360.
 
Monte

Monte

Member
Joined
Apr 30, 2020
Messages
88
Reaction score
47
Points
18
Found out yesterday, the bay is actually 16'8". Which actually works with the LONG wall mount brackets from PDQ that are hopefulluy, coming.

I still am going to have to figure out the height issue, cause I have windows to 112" on the side wall. We believe the rail normally is 106" off the floor.
 
Monte

Monte

Member
Joined
Apr 30, 2020
Messages
88
Reaction score
47
Points
18
It is/was the stand for the rails that I needed...I think now, wall mounts will work....Thanks
 
You must log in or register to reply here.
Etowah
Top