Thank you for the diagnosis @Randy
I am not sure what the payout switch is. Is that a part I could order from Kleen Rite? I scrolled through their Hamilton parts but dont see anything for that.
I have a hamilton changer dispensing quarters that keeps getting "stuck". Most common error code is 4 flashes, 3 flashes. I will try to flip the manual switch and just hear a hum. The solution is typically to dump the hopper out refill 10% full then reset and its good. Only one time there was a...
I have a car wash close to a big mountain mine and I get very heavy mud usage. We scoop mud from the floors when cleaning but a lot goes in the pits. We just filled the pits again after only 2 months.
Whats the best design for a mud catcher cover over the pits?
I was looking at this design on...
Not sure how you have your equipment plumbed and wired but I would try pulling out the solenoid and plumbing straight through with a shutoff valve in its place to try and debunk my theory of bad solenoid before replacing.
This is a good point. You dont need 4400 GPD. I would try and simplify your unit down to 1 membrane and be closer to 1000 GPD production which is plenty. If your unit has sat for an extensive period of time then your membranes likely need replaced and they are not cheap. $400-500 each. This is...
I have been exploring new lighting for car wash bays and if I am going to spend the money I want to in other words "go all out" except when I say go all out I dont mean to the tune of 20-30K for some of the big names in car wash light shows. Basically I was thinking of doing LED Hexagon Ceiling...
Im not familiar with the pumps you have there. You also dont have pictured your pre-soak manifold but assuming its the same as your other products this is how I dial in my products. Turn air completely off. Then turn on your presoak and get the pressure up on the product between 40-60psi...
Anyone that makes the decision to purchase Nayax devices for their site can use this link for 7% discount.
https://nayax.pxf.io/c/4298119/1454672/15225
Or promo code: REVESTOR
I do get a referral bonus for that link full disclosure but in return I am also willing to help answer any...
When I scroll through my transactions I can see payments have been declined but tying that to a debit or prepaid card is difficult. When I review the cctv footage most customers try a different card or may go to the changer to use cash instead. I am not worried I am losing business over it.
No...
I am updating some of my signage and I am working on keeping everything simple and clean looking. I also have some functions that suffer from lack of use primarily because my customers need to be educated or feel like there is value in the product so here are some name changes I am considering...
Hey everyone thanks to this forum I took on a project I knew next to nothing about and it came out awesome. I took an old Hamilton DRS-CRC and updated to an MEI validator and used a Nayax CC reader to vend the tokens. I highly recommend working with Randy if you guys have a project like this.
I...
Can you speak to the quality of the booms that premier provides? Some of the complaints I see with Air Shammee is that the boom is not long enough and that it doesnt angle down at the tip and eventually wears out the hose.
I run timers on our dryers to track usage. At the current rate we will have them paid for in 1.5 years. It doesnt take much uasage really to be profitable. The cost to run them is minimal compared to your other selections that have chemical.