Recent content by twinfalls

Hello I got a airless model of dosatron and my soap is coming out straight soap and water. Kleen right told me my units don't require air and can be used for all low pressure like foam brush, tire cleaner, wax. Any one know what I maybe doing wrong like a setting or something else I need to get

I bought weepmizer for my 4 bay car wash. How does it look up to the waterlines all I see is a yellow wire for sensor. Can you send me photos of your set up and explain the water hook up? They didn't send any type of diagram

Hello I have upgraded all my low pressure to Dosatorn wall mount units.. I have a large tank with 3 departments I no longer need because the new system don't require it I also got 2 new wall mount tanks for raise and HP Soap. The rinse is currently gravity fed through the old system to my cat...

They already are should I just change my saroids valves .

Use to be a outside bay or looks like. Top one that says bay out was it. I broke down and just ordered air logic systems from kleen rite. - so when I put them in the HP Soap runs off them the left old solenoid valves still. What should I do with thoses how should my HP Soap and wax set up be...

It's a simple question. I need advice on where these lines go. The small lines on the solenoid valves I'm not asking what I need. I'm asking where do these lines go

Other picture provided

I have a 4 bay car wash, First row down is Presoak/ tire cleaner Middle is wax Right is HP Soap All pumps are hooked up to the stainless steel soap bins the. I just bought this car wash last guy has these cut I need to know where the lines hook up too in the picture

I am replacing these and bought this car wash with a lot of hoses cut. Can anyone tell me where these lines go? I'm new to this figured out everything but this system for relocating these lines