Recent content by Splish Splash

By Dixmor are you referring to the actual countdown timer displayed to the customer? If so I did not know that this actually controlled the dryer. I just assumed since the dryer time was set within the J0 that it was controlled by it. I thought it just sent a pulse to the display to tell it to...

Well, just turned the dryer output on and left the dryer run for a good 5 minutes with no issue.

Will do right now.

I have checked the amp and settings and tested that the eyes are seeing the break at all points between the exit door eyes. Still no luck. I am also having no issues with the exit door closing after a customer exits the wash so that tells me that the eyes are working properly.

Both are long bay setup.

I've been having an issue recently where our stand alone dryer in one of our bays shuts off early. I have both bays set to 63 seconds. This bay sometimes shuts off with approximately 45 seconds (not always) left so they are only getting around 15 seconds or so of drying time which isn't enough...

Thanks boywonder. I guess I was skipping past the easy possibilities and making it more complicated than it was. It was the up door relay in J2. All is working just fine.

I have a Laserwash 4000 with issues. The door goes up, car enters and wash starts just fine. For the past few days the exit door has not opened when passing the mid limit sensor during the spot free (last) cycle. Also, the exit door has not been opening normally when you walk between the t-bars...