Randy's latest activity
-
RRandy replied to the thread Push Lok install.I always use a Flare fitting on any component that I might have to replace or disconnect at sometime. Like on your air regulators...
-
RRandy replied to the thread Push Lok install.I soak the hose end in very hot water before I try to slip it on the fittings, never had a problem getting them on.
-
RRandy replied to the thread Poll: Has your car wash been .....I don’t know where to start. In the last 6 months we’ve had so many break-ins it’s hard to keep them all straight. In one night we had 6...
-
RRandy replied to the thread Bay safe…..It looks like the "T" handle lock has been drilled on. Can you open the lock and safe head and remove the box? If you can remove the...
-
RRandy replied to the thread Mercury Relay vs Fuse to Protect IDX MX-8 / IDX MX-10 Foamy Brush & Tire Cleaner.You want to use 20 amp fuse. I believe the MX-8 is rated at 25 amp load. To install a Mercury relay it would be the same as in your...
-
RWe were in the totality zone. Been planning this party for four years. A great time was had by all.
-
RRandy replied to the thread Changer install.Yes make the hole an extra inch all the way around. If you make the hole 20 inches wide and 30 inches high you should be good. The parts...
-
RRandy replied to the thread Changer install.Nice. What kind of changer are you replacing?
-
RRandy replied to the thread Changer install.You want to use a concrete saw that has cooling water, that keeps the dust down but it still makes a mess. Last one I installed I made...
-
RRandy replied to the thread Low Pressure Boom Leak.It's a common Brass 3/8" Male Female 90 deg. Street L. You can buy them at just about any hardware store, KR, Lowes, Home Depot, Ace...
-
RRandy replied to the thread Low Pressure Boom Leak.The first thing you need to do is to figure out what is leaking. Is it the street 90 or the hose barb or the hose. You also need a...
-
RRandy replied to the thread Need a technician.When you say your "Clock" is displaying an error you must be talking about the TIMER! Do you know what brand of Clock/Timer you have...
-
RRandy replied to the thread Slugbuster vs Sensitron.If I were going Quarters only I’d go with a Slugbuster 1 P-47, if I were going to use Quarters and a Token I’d go with a Slugbuster II...
-
RRandy replied to the thread Repair Day.I just love going to the car wash on a beautiful Easter Sunday morning to fix the foam brush system when I got a houseful of relatives...
-
RRandy replied to the thread Pump life expectancy?.That would be about right, 2 or 3 years on a set of seals and valves. I don't know much about General pumps. But you want to look for...
