Recent content by Monte

I believe I got that 6 months ago on my 360+....I decided to change motor/gearbox. That cleared everything up...but never can be 100% what specifically was the problem. I think it was tired gearbox.

I like it....I wouldnt be afraid of setting up that system in one of my sites. My experience has been, the older, simpler systems can be dependable and bullet-proof..while the more sophisicated, newer systems give me grief. Also, I am glad I started with an older straight-forward system like...

Has anyone boot-legged a Crypto swiper onto a Unitec Portal Ti yet??? Crypto told me they dont offer a retro-kit for the Portals....but I want to find a way...

I see this alot....in my situation, the guy exiting the bridge to drive under the stand alone blowers...decides to backup and use up all his time. If he is able to be seen by the bridge exit ultrasonic/sensors, the brain thinks its the stacked wash and will get confused. Alot of the time, the...

What IBA? On board dryers? Distance from bridge to SA dryers???

Dont think you can do that....I understand the QR code options are one and done. I put a plus on a vac to experiment. We have same concern, we really want an attendant card, but it isnt available.

What was the error code for that issue? Thanks I have not seen that yet.

Be more specific....there are a lot guys here that will help, if you are more specific on the issue.

For you guys who like to compare and experiment with other brands....you should try CK Enterprises line of products. We were Quest for 3 years....good results, clean cars, but when prices went up...we gave CK Rep a chance to trial his line. We are now 100% sold on their products and ability to...

I'm trying to find out about what CC/contact less units people are using on there IBAs. I have all Portal Tiplus units. Apparently, Crypto doesn't offer retro-kit on these...cause, that would definitely be my first choice.

I was having same issue for a week. I will check with my nerd tomorrow....I believe he fixed it. I'll get back to you.

It is/was the stand for the rails that I needed...I think now, wall mounts will work....Thanks

Found out yesterday, the bay is actually 16'8". Which actually works with the LONG wall mount brackets from PDQ that are hopefulluy, coming. I still am going to have to figure out the height issue, cause I have windows to 112" on the side wall. We believe the rail normally is 106" off the...

I will have to get back with that number. We are removing McNeil short tunnel and replacing with pdq 360.

I have purchased a used 360+ that has wall-mount hardware for the rails. Does anyone have a stand, in any condition, they would sell that would work?? or trade me for the wall mount hardware?? PDQ wants a ridiculous amount of money for a NEW SS stand. I have 2 other 360+'s that are operating...