Recent content by Mattwash

South side of Houston TX $3.00 - 4 min wash $2.00 - 4 min vacuum

Have you looked at the Control by Web x-410? Can use it to Monitor pulses and configure the device to send pulses via 24v relay, whether controlling a device or there are a number of sensor add ons. Sensor Dynamix has something similar but their fees add up quickly if you were to implement...

I just use any anchor bolts or bolt with no head, then place quickrete adhesive in the hole. This stuff is uber strong...

Ive got my booms mounted to 4" I beam using stainless 1/2" u bolts. Air shammee 2 motor, I built this bracket.

Recently remodeled Outboard Motor Flush and Air Shammee 2

When timer stops in my bay, I changed the dixmor where the customer can deposit a quarter within the next 20 seconds to restart the timer.

I agree with you completely. The car wash isn’t supposed to be a hobby. What are your vacuums priced at?

One of the few studies I could find on national water rates. Utility water bills increased 43% from 2012-2021. https://www.bluefieldresearch.com/ns/up-43-over-last-decade-water-rates-rising-faster-than-other-household-utility-bills/ Now take into consideration how much have chemicals, energy...

Impressive! This is very reassuring to hear!!

I’m not opposed to that price. I was in the middle of a remodel and slowly adding items. Definitely going to take a look at price increases after the new year.

Here are mine. 2 for each bay.

Not sure about increase in sales. But when I remodeled my wash, I did starting price of $3/4min. Occasionally someone will say something or someone will drive through and leave after looking at the price/sign. The only self serve close by is a couple miles away on the opposite side of town, has...

Mine are actually held on by a 1/2” stainless u bolt and 1/2” bolt on bottom that goes through a I-beam. As for the motors, I built these mounts behind the metal walls to support them. do your booms swing back to position with that lean? Noticed mine go back but not as far as I would like and I...

In all honesty, I searched the kleenrite site and didn’t see this one. Feel like some items on the site are well organized by part type, other things are clumped into brand. Just like when you do a search on the site and attempt to use the search filters. So many items are missing things like...

Please see links below. I went back and used Gorilla tape to seal between the clamp and 90. Also used self tapping screws to prevent the 90 from slipping off. After doing this, I agree with @Kimberly Berg the boom could use some length. I will prob get 3’ of stainless exhaust and have a 90 bent...