Recent content by kroy

Thoughts on gantry style vs inverted L for touch free IBA? I'm hearing that the gantry style units may require more maintenance, but that they do a better quality wash. I like the look of the inverted L and having a more open uncluttered bay but not if comes with more maintenance!

Although I have no car wash experience, I've been doing residential construction for 20+ years and I work for a pre-engineered metal building manufacturer. I can put up a metal building CHEAP. Planning on using some nice architectural metal panels for curb appeal and using block for the wash bay...

Anyone have a proforma spreadsheet to share? I'm planning on building a new car wash with a single IBA. It's a small corner lot with a traffic count at about 10,000 cars per day. Looking like my total cost including land, building, and equipment, will run $325,000. What kind of capture rate...

Paystation is "Hamilton Goldline Plus". Dryer is a 45HP with added elephant trunks on side, free standing. Standard razor, not the higher end edge. System to be wall mounted. After reading through every post I can find, this seams to be the best brand for many reasons but not sure I can justify...

The $203k was for razor, paystation, RO, dryers, and install. But no doors(which are expensive). And I was told I would need my own licensed plumber & electrician on site that would be at my expense on top of the 203k

I just received a quote today for a WW razor , including all the other equipment needed for a new site. The total for all the equipment and install was a total of $203k. I think this is waaaaaay too high. I was ready to go with WW, now looking into other brands.