Fatboy769's latest activity
-
Don’t they all? -
Its possible that your compressor is the problem, or contributing anyway. I've observed that as they get older they produce more water...
-
FWIW....To minimize/reduce moisture, I lowered the cutoff PSI from 125 to 100 on my 80 gallon compressor. The head barely gets warm...
-
They sell new hoppers for $99-136 range at suzo-happ. You can replace the belts and clean the hopper, but if its been in service for a...
-
Fatboy769 replied to the thread Possible to get an email or text if changer is down?.According to the Rowe manual, the out of service light is 12vdc
-
Fatboy769 replied to the thread Possible to get an email or text if changer is down?.Just installed the Yolink device and hub that @Greg Pack linked in this thread, to email me when a customers automatic goes out of...
-
Check to make sure your refrigerated dryer is still working. One of mine had an auto drain dump that quit working and it was allowing...
-
Since air cools as it expands, and cooler air holds less moisture , the moisture will condense out as the air moves away from the hot...
-
Bingo! Due to humidity in the equipment room and the fact that compressors produce condensation… Install an automatic tank drain on...
-
I dont know what your time frame is for buying a wash. I know I started looking at them when I was 24 yrs old. I had sold a very...
-
Water in air lines kills flojets. I use Flojet extractor dryer filtration system @ the air compressor and just before presoak and...
-
Fatboy769 reacted to Thisguyswash's post in the thread Help with cavitation after replacing seals and valves. with
Like.
So I got it fixed tonight and it was the leaking soap solenoid! Hard to believe that such a small leak could cause all that. I guess on... -
My red arrow is pointing to the ground connector on the motor. Can you take a few wide angle pictures of the motor area? If it's a...
-
Did you switch the motors to a different vac? If so did the problem follow the motors or is the problem still with the original vac...
-
Did the problem follow the motors? Or problem still in original vac?
