Softgloss Maxx will come to back of bay and not move forward. I can manually move it about 2 feet forward then stops, move it back a few inches then will move forward 2 feet again. All prox’s seem to be working and and can hear the contacts close. I changed k12 just to make sure it was ok, still...
No printer for me, I think I have had 1 person in 4 years ask for one. I screen shot my daily report and sent it to him.
System works great, zero problem in 4 years.
My rear trailing air has a new Mac valve and new gauge and the air shows about 3lbs but is very hard to adjust. It jumps from 3lbs to 25lbs very quickly. Is there anything else I should replace to get a smoother reading on my pressure?
Softgloss with short bay, top wash- 2nd pass of brushes comes to rear of vehicle, rear brushes come together in the middle back all the way to the rear of the bay. Rinse starts, gantry starts to move forward, rear brushes start to move to the side of vehicle but doesn't quite get all the way to...
The $13k repair cost came from the tall bush rear cover up by the arm that folds in. It fell down to the back of the machine and the machine pushed it against the wall. This causing most of the covers to be crushed on the right side. Then the wiper covers, wiper motor belt etc were also damaged...
Yes I have a clearance bar, but the headache rack on his truck was self-made and didn’t conform to the cab of the truck, you can watch the video and see what I mean.
My insurance company didn’t care a bit to help other than, “ well if you can’t prove anything to his insurance, you can claim it...
I had a customer enter the bay with a non-manufacturer flat bed pick up. The headache rack caught my SOFT GLOSS MAXX, did over $13k in damage, his insurance said “since he was still when the accident happened, it’s not his fault. Help me out with your advice!!! Have 5 cameras that caught the...
Ryko SGMAXX $8-$10-$13-$15, 86% are going with the $15. We wash a average 65 cars/day. I am on a very busy street around all the major stores.
HEB put in a new PQD360 with the top wash at $10-$1 with gas.
They might wash a few more cars than me, but I can’t complain about my numbers.
This would be be an easy fix. Search some other boards and you will find some with temp sensors etc. It all depends how much you can actually do yourself, it might not be a lot more $ to add all these goodies with the current door system.
Good luck...
Do you have to continually hold the switch while the door opens and closes or is the switch momentary? I’m asking because I have an answer to remotely control your doors and just want to steer you in the right direction. If you could take a few pictures it sure would help. You can message me if...