Recent content by Ceverett

Not a Razor, but pretty much all machines I install get electrical and plumbing routed through the wall like this

If your TDS is 100 anything left on the cars is going to spot like crazy

What do you mean by the same with RO membranes?

You should absolutely NOT feed your chemical injectors hard water.....your chemicals will barely work with hard water and your injectors will constantly be clogging up I would use the water heater to feed either soft or RO water to the LP holding tank You will get better results using hot...

I believe List was around $800. APG is the way to go....last time I spoke with them they can also repair, but the lead time was 2 weeks

Once you get them clean, I have a lot of customers that have purcleans window washer system which basically just rinses the windows with spot free water after a certain amount of cars. I'm sure a clever individual could come up with a system without spending too much.

http://www.pdqinc.com/products/laserwash/index.asp#5 click on the vehicle wash full presenttion At the 2:20 mark it shows the "waggle" motion on the arch, it's a pretty nice feature....wash customers seem to love it. The arch can also be set up for a mirror wash so that when it comes by the...

I just repaired a hamiloton acw in New Castle,DE that had been hit. Thankfully they didn't manage to get in.

If its leaking water between the head and the pump then it is more than likely a seal is bad. Did the pump repair place only replace the valves? If you take out the brass seal cases sometimes you can remove the seals and slather them up with some vaseline and it *may* stop the leaking for awhile

If you do find a pump shop to rebuild for you get an estimate first....i've seen alot of shops charge almost as much as you can get them from kleen-rite for new. Rykopro- What general pump from PDQ cost's $7000??

Try putting a few drops of oil on the hose barb/check valve for the air that goes into the flow jet.

You might also want to check the distribution block up in the bridge, i've had that clog up before and it caused the problem you're describing. On the aftermarket valves...couldnt help you there

I've seen it happen at one other site. Call PDQ and explain it to them and i'm sure they will take a hardware change into consideration.

I'd also recomend adding another thermostat to a different location so that it will always read the lowest temp in case one craps out on you.

I'm sure it would boost sales a bit, but the high mall kiosk rent would outweigh any kind of sales boost your wash would generate.