Recent content by carnut2

Etowah
  1. carnut2

    Repeat offenders and the Kia Optima

    Had a customer claim we scratched his rims on his 2013 Kia Optima. I reviewed his video and sure enough the wheels come in fine , he enters the conveyor cleanly and there is no apparent reason for the damage. I checked my conveyor up and down and see nothing. So I call the dealership and...
  2. carnut2

    R/O arch leaking

    Yes it is siphoning from the RO storage tank. Wondering how it can be getting past a brand new "normanlly closed" solenoid. Am installing a stainless steel check valve at rainbar. Does the rainbars installed upside down still function normally?
  3. carnut2

    Peco Dryer Housing

    Thanks, I have purchased a plastic welder and will give it a go.
  4. carnut2

    Peco Dryer Housing

  5. carnut2

    Peco Dryer Housing

    Anyone had any issues with Peco (or others) dryer housing splitting or cracking in the "V" where the air chamber comes down?
  6. carnut2

    responding to on line reviews

    Anyone else get burned by the invisible reviewer? I have, on two occasions, tried to be proactive about negative reviews posted on line. Both times it turned out to be a circular no win situation. I try to find out if the person told an attendant at the time that he was dissatisfied, he says...
  7. carnut2

    Homemade rain/rinse bar

    Thanks, I should have noted we will be using low pressure (90lbs) fresh rinse water.
  8. carnut2

    ICS touch screen issues

    It did turn out to be the touch screen. Was not that expensive or hard to install.
  9. carnut2

    JE Adams motors going out

    No apparent dust problems, and vacs are free and on a three minute timer.
  10. carnut2

    JE Adams motors going out

    Mostly using Domel 492. They go out before I have a chance to change brushes. Sometimes 4-5 times a year.
  11. carnut2

    JE Adams motors going out

    Have a continuing problem with replacing motors in our JE Adams vacs. Have tried different brands but still the same result. Any ideas?
  12. carnut2

    Drying chamber

    Intakes face exit. Door is shut between cars. You are correct, we are drawing air (with mist) into the intakes.
  13. carnut2

    Drying chamber

    Depending on wind direction, a lot of mist from rinse arch, even r/o rinse is pushed into drying area, being sucked up by dryers and dispensed on cars.
  14. carnut2

    Drying chamber

    How close would this wall be to the actual dryers? And we have a tall (20ft) roof. Should the roof be lowered in this chamber to the dryers? Thanks for all the help.
  15. carnut2

    Drying chamber

    Little bit of both. Tunnel sits north south, so we get wind from both directions. Have air lift vinyl exit door, but when dryers are on, it is like a typhoon.
Top