Recent content by carbe

ok ..i will check the check valves, will update.

Almost all bays in my SS leak foam brush soap when foam brush is on in a different bay, happens mostly when foam brush is used in the adjacent bay but it doesn't has to be adjacent bay, and some bay is worst than other. It is not much of the leak but its there, even on the days the bay is not...

problem solved, well before trying anything that needed more time and labor I started off with changing the belt and first try it worked.!! Hooray. Thanks to everybody's guidance. I still wonder if it would have been a leak wouldn't the pump be pulsating all along as opposed to this did...

So, if it is drawing air what are the places I need to check for leakage and what should I look for? If it was a leaking wouldn't the pressure low all the time, this pump starts at low pressure pulsating then it takes about two minutes to reach to 1000 psi then it pretty much stops pulsating...

Have a 1.5yr old cat 310 pump ss bay, it was shut down for almost 10months and now restarting the bay is causing the pump to pulsate for 2min, initially the pump wouldn't go beyond 500psi i then changed the regulator which worked and now able to get to 1000psi but only after couple minutes of...

Well guys this is getting ugly, now tahat i have tried all i could nothing is getting better .to brief what all i tried 1. Changed the timer no difference. 2 checked for loose connections nothing found I have not checked the rotary knob i dint know if that is a valid test I however have noticed...

no this is a different bay..i still need to work on this.

i really like and appreciate the enthusiasm here, all the effort and knowledge everybody is showering to help some random guy (me). well answering to some of the questions that were raised. for the type of equipment i use 2 stack rotary switch, ginsan coin acceptor, soap gravity fed , by...

this is exactly waht i was looking for, thanks a lot for the diagram. the link makes me curious how you found that on KR.

i bought this switch from KR ,STKR8, now i am not sure if it has a jumper on it, can u give more detail on it.

thanks for all your advice and expertise, now here is followup issue, i tried changing the rotary switch= 2stack 8option yeah with the stop option, now i don't know where i messed this up because i don't know how the connections are made i tried to copy connections as they were before but...

yeah i do use dixmore timer and i do use rotary switch and ginsan coin acceptor, i will try swaping a new dixmor and see if that will change anything.

my one of the bays has trouble running when put coins, it runs intermittently as if there is a loose connection. and that is only true for high pressure with other options it runs fine..however this does not happen when it is run by putting the key (manually). so i cannot suspect any cont actor...

so looks like the way to go with this is replace...any suggestion to prefer one company/type over other. i don't know which once are there now which is stuck since this will be first time i will be replacing, i have 7options in the bay.

i had a bay shut down for couple of weeks for service and to fix few issues now when it is ready, the rotary knob is tight and hard to turn. i tried to grease and put anti rust in case it was rusting from just sitting, cleaned with wd40 but no result. any idea why and what is the way to get it...