Recent content by Camp4042

Your best bet is probably Kleen-rite. We picked up the mytee-lite 2 for around $750.00 with freight. It's a nice machine and its a good size

I had the same problem with my bay lights. You have to change the breaker in the panel to 120v. The only 2 cfls they make are either 120v or 277v. We changed the breakers in our panel to 120. Its not bad to do but you have to make sure you have room in your panel to do it.

We are really slow right now too. We can't figure out what's going on, gas is coming down and we still aren't busy.

Randy, The water cost you $300-400, but what did you pay to heat that water? The 4 bay system is about $2500.00. In the midwest we had a really cold January and I just got my last gas bill and almost fell over

I did this to my wash and it works great. They make a bigger cfl that is a 105 watts that puts out a great amount of light. I have Cooper fixtures and there is a local lighting store that I get them from and I pay the same price as I would for metal halide bulbs. You don't need an adapter...

They told me a 55 of RV is about $180.00 from where they get it from. For the season they said they use about 90 gallons, depending how busy your wash is and the outside temp. Its set up to purge 1 minute after the customer is done using the bay, the busier you are the less it will purge. One...

Just came from the MCA show. A company out of Frankenmuth, MI make a system that uses no water and purges and injects the lines after the system is used. There called Polar Freeze Guard Systems. I was very impressed and is very inexpensive.

Earl I had this same problem with the my tunnel watch controller. It was the telephone style connector used on the back of the controller. You can buy the connector ends and the tool to attach them at any hardware store. Just cut the connector and put the new one on with the tool. Just make...

Replace the keypad controller wire end I had this same problem. The keypad controller wire has a telephone cord end and after heavy use it becomes loose. I cut the old end off and replaced it with a new one and the problem was fixed. All the hardware stores sell the ends and the tool to...