Big Chris's latest activity
-
Big Chris reacted to Buckeye Hydro's post in the thread Resurrecting a R/O system. Please help me. with
Like.
So for the housing that is fed directly from the pump... the water enters from the bottom so the brine seal should be at the bottom... -
Big Chris replied to the thread Resurrecting a R/O system. Please help me..Can someone please help me identify the direction new membranes get installed? One end has an o-ring/seal the other end does not...
-
-
Big Chris reacted to Buckeye Hydro's post in the thread Resurrecting a R/O system. Please help me. with Like.
BINGO!
-
Big Chris reacted to Keno's post in the thread Resurrecting a R/O system. Please help me. with Like.
As stated earlier, your membranes are toast, they can't handle sitting without use. I would determine how many GPD you need and buy...
-
Big Chris replied to the thread Resurrecting a R/O system. Please help me..Yeah Rudy, I have a large snap ring tool, you actually screw the handle to open or close the jaws/pins. I'm wearing safety glasses...
-
Big Chris replied to the thread Resurrecting a R/O system. Please help me..Yeah the solenoid is fixed, in the attached image the plunger (cylinder with slot cut into it) with the red spring behind it was sticky...
-
-
Big Chris replied to the thread Resurrecting a R/O system. Please help me..Thanks everyone for the replies. Rudy good info there on the ebay membrane, thanks so much for sharing. Paul and Russ, thanks again...
-
Big Chris replied to the thread Resurrecting a R/O system. Please help me..Firstly thanks for the replies fellas: I'll try to address everyone's comments. Chlorine and the Charcoal filter. There is a chlorine...
-
Everyone, I need some help. I own an older SuperWash site, and when we (the Mrs & I) bought it, it was in rough shape. I've been...
-
-
Big Chris replied to the thread FRP Panels.Jim, I have FRP in my IBAs that needs replacing, this is a project that's on the list for this summer. Really interested in how this...
-
Will do, before and after.
-
I would move wheel brush to number 4. Mine gets lots of use. Everybody likes clean wheels. Plus it takes time to do the wheels and...
-
I replace brushes several times before I replace the motor. You definitely need to make sure to replace them before they get too short...
-
Did I mention that I have an aol address… Oy!
