Recent content by 22MVR22

Typically the red light means a the sonar is not getting the return signal from whatever it is bouncing off of. Be sure the floor is draining properly and doesn't have standing water under the sonar, or that the sonar isn't pointing into a pit with standing water. The water surface will...

Washworld strongly recommends using Jet Lube Artic Grease. It is the best grease for the application and is what is used when the machine is built. Any other grease cannot compare. I would also strongly recommend reviewing the Maintenance section of your owners manual. This lays out basic...

The Profile monitors the brush amperage, if a vehicle moves during the wash, the brush amperage would spike up and adjust or stop them because the vehicle would no longer be where the Profile measured it.

I would advise not running without a carriage cover, even if it is only until a new one arrives. Although it is a wet environment, the cover will keep direct water and chemical spray to the components inside the carriage, like the motors or wiring junction boxes. I would try and find a way to...

Are you saying the cover obstructs the rear prox switch when it moves, or do you mean the rear sonar in the middle of the carriage?

These are some alternative Arch covers Washworld sells. It would require the side arch to be replaced since they added some nozzles to it(21 vs 19) It can retro-fitted to any Razor, HV, or PDQ 4000.

The Razor also runs a start up test after every wash to make sure everything is in it's proper place, which will take a few seconds. Also, If you have any wash packages that end at the rear of the car, this may be the time it takes the Razor to travel back to the Home position at the exit end...

You can most likely eliminate the High Velocity UCC by swapping out relay 1200 for entrance door up and inspecting the wires on terminated on the relay. The relays for the door controls are used as a set of dry contacts, if the relay isn't working properly or if there is a loose wire on one of...

Just for future reference, the e-chain cross link can be removed with a flat head. Just insert it into the slots like in the pictures, apply some force and pop it out.

I would call into Washworld Tech Support, they would be able to explain any options.

Any cycle on Razor 3 can be programmed as a buy up, but they cannot be individually selected by the customer because there is only 1 input available on the Razor 3 PLC. Example: Wash 1 has Bug A Salt as a buy up, and FNF as a buy up. The customer cannot choose to only buy FNF and not Bug A...

Razor 3 has 1 buy up input. You can program more than 1 buy up in the wash packages, but when a buy up is triggered, all buy ups that are programmed will be added to the package. Razor 4 has 4 separate inputs for buy ups, making it possible to program multiple buy ups in a package just like...

Does the wash get greased every month? If so, what kind of grease are you using? The idler wheels will have some flex in them, take a tape measure and flex the idler wheel to the left and measure from the carriage frame. Then flex the idler wheel to the opposite direction and measure. If the...

I would also double check to make sure your 2nd soap valve is not stuck open or intermittently sticking open. And the relay that controls this valve isn't sticking closed, causing the valve to have constant power and to stay open. If it is, the chemical may be getting siphoned when other low...