Will the Microcoin QL insert (actual acceptor) fit into any other mounting faceplate? The JE Adams website shows a Microcoin QL mounted in an all stainless faceplate. The faceplate they use for this seems to be similar to the IDX faceplate.
Where should the breakaway fittings be installed? At the inlet to the high pressure gun or at the end of the high pressure boom or both?
Also , there are several types to choose from, Suttner, Mosmatic, etc. Any recommendations?
Thanks
My old propeller 45000 BTU Reznor unit heater needs to be replaced. The equipment room walls are masonry and the roof is uninsulated metal. The dimensions are approximately 20 x 12 and the ceiling height is 11 feet. Initially, I was going to replace the heater with another 45000 BTU Modine Hot...
Over the years, I have had a number of different MEI acceptors in service. And yes, we have had problems with five dollar bill acceptance too.
As strange as it sounds, I have noticed that if I crumple up and then flatten the five-dollar bill that the acceptor is rejecting, it improves the...
Four used Dilling & Harris touch select controllers. These are for decoding the data transmitted between the meter box and pump plant over a data cable. These came out of the pump plant electrical cabinet, not the meter box.
guaranteed to work