i have a small iba with a new ww razor with airlift doors. there is not enough room on ceiling or walls above rails for a tube heater. it is an end bay though with block walls, and my thought is to attach some type of heater to the outside wall and knock out a couple of blocks to force heat...
anyone out there have one? i have a soda machine about the same size built into my front equip room wall that does less than $1000 a year, thinking of trying the water vend. not interested in adding a large ice/water unit on my lot.
if there is such thing!? looking to install an automatic with dryers (i want 3 -15 hp) outside the bay. problem is a residential yard (with a crabby lady) 50 feet behind. any ideas?
i read in a previous post somewhere about using repair kits in the fluid controls high pressure swivel. I called kleenrite and ordered a repair kit and asked about a special tool to take it apart and was told they don’t know anything about that. Is there a special tool? How do you take them...
just put in a new razor edge and trying to maximize performance. one chemical rep says tri foam first followed by hot wax, rain x, then ceramic.
another rep says ceramic then stack the waxes on top. what thoughts are out there?
i am considering adding these as i believe my location is good and have the room on my lot. my problem is that i have absolutely no idea what kind of money they could bring in and i’m not interested in what the salesman estimate. if anyone on here has either and would be willing to talk to me...
just had a lot of snow and salt here and expect the next few days to be so busy with people wanting to rid the salt that i expect all 8 bays to be non stop all day. unfortunately vacs are in front of the bays and of course there will be a couple of people that will want to spend an hour or two...
I can’t figure out where the squeal is coming from, as it’s very sporadic. it will do it on the first to presoak‘s then not on the high pressure. And also it might be only on 1 out of 50 cars
first presoak pass is drawing too much chemical. noticed going through quicker than normal. first measurement was 5 oz., next 2 vehicles were about 10oz each. i think the norm is about 2 oz. i left the tube in during the 2nd pass to make sure it wasn’t drawing then as well and it was not. this...