Search results

  1. R

    Water Wizard 2.0 - Alarm 58

    Greg, Thanks for your response. Yes, I located the exit eyes and one of them had fallen down in the can and was no longer communicating with the opposing eye. Appreciate your help.
  2. R

    Water Wizard 2.0 - Alarm 58

    Please Help
  3. R

    Water Wizard 2.0 - Alarm 58

    Red light won’t reset after wash has finished - so checked on wash end of day today and noticed it was taking approximately three minutes or more for red light to reset after customer exited wash - I have checked treadle eyes and all is good - I am getting alarm 58 - customer waited longer than...
  4. R

    Alarm 58 - water wizard 2.0

    Okay - so checked on wash end of day today and notice it was taking approximately three minutes or more for red light to reset after customer exited wash - I have checked treadle eyes and all is good - I am getting alarm 58 - customer waited longer than 3 minutes to exit bay - have no clue what...
  5. R

    Tearing out old trough

    Yes it is on the roof - just old and rusting out - probably just going to need to get someone to build me a trough like the one that is there and replace - would just be nice to do away with but Mother Nature I assume says no to that - will wait for a few warm days and just get it done - thanks...
  6. R

    CAT 3535 on water wizard leaking oil

    Thank you for your response, I did just that and all is good now.
  7. R

    Tearing out old trough

    Has anyone tried to remove the old roof trough and replace with new. If so what material did you use and where do you get it. I have even thought about not having a trough at all. thoughts suggestions, thanks
  8. R

    CAT 3535 on water wizard leaking oil

    I came in this afternoon and noticed oil in the floor so I looked up under the pump and oil appeared to be leaking between the pump and head. Is there a seal kit to fix this issue and it is possible to leak oil between head and pump on CAT3535
  9. R

    Coleman Self Serve - Foam Brush

    Thanks for the advice. I have a spare motor for the foam brush so I will swap it if I continue to experience the issue. First I am going to switch to a 15 amp slow blow fuse. I am currently using a 10 amp. “May be the problem but not sure” appreciate all the support as we all know it can be a...
  10. R

    Coleman Self Serve - Foam Brush

    I keep blowing my fuse for foam brush in the hand rack (power pack). Any suggestions? I replace Fuse and foam brush works for a few days and then I get a complaint that it’s not working. Replace and works again. Have no clue what might be causing this. phone - 469-247-1628 Robert Story
  11. R

    Water Wizard 2.0

    Need some help, phone number 469-247-1628 if you would like to cal. Currently I am receiving alarm #25 - Top boom prox came on when boom was below the sensor head. Check for abnormality. - I have replaced target ladder prox switches Boom will go down about 19 to 24 inches and then machine...
Top