Search results

Ive had good results with hyper lite.

Got rid of mine. best thing i ever did.

Check your tires. if one is flat the speed controller will shut down.

Have the same problem, Hamilton said the controller needs replacing.

Nope, after 13 years it's still a daily chore!

Just when you think your gonna get past all this weather, crap like this happens! 1 /1/2 " incoming water check valve. This came in from the city water line, and shut down my water, turning off my weep system in 15* weather! now everything is frozen!

90w synthetic. You gotta remove a plug and I use a small funnel with a piece of tubbing attached. fill until it just starts to overflow.

The sticking you talk about is burnt contacts. That is an OLD contractor. A simple 2 pole 30 amp contractor from any HVAC supply house would be fine. Make sure the coil voltage is 24volts. Your looking at less than $25.00 for that part.

I have some extra Standard Change Maker parts, hopper, board, old MEI acceptors, stackers. Are they worth anything or just trash?

Any three phase protection device from an electrical supply house.

Yep, everything is costing lots more!

I added a note to my cryptopay, bay sign instructions. "You MUST push the STOP button to end charges!" Stopped 99% of my complaints.

bert79, they want that for razor, no pvc walls, and no paystation.

Getting new doors My installer is proposing the entrance door to be w/o counter balance, but the Exit door has the counter balanced door specked. Why would he do this?

Thanks for your replies. Trying to get some kind of comparison. I'm replacing an old High Velocity. With the companies that sell, it's hard to get any competitive bids.

How much does a new Razor cost?

I have a wash in tulsa, ok that i need a bid on!

One thing that helps with the swipers is to clean them often. I clean mine at least once a week, and it seems to reduce the multiple swiping problem.

Just an observation. I had trouble with WW machine, doing similar stops. It was rubbing the pros sensor like in your pic. The Service techs could not figure it out. I replaced all of my rollers and the problem went away!

Where do you get the resin?