Search results

Keeps it from sliding, not what jeeps it from sliding... fat thumbs

Good Sunday Morning. Got to the wash to find a bay with no pressure. Checked and found the motor pulley loose. I can slide it back over, but I don't know what jeeps it from sliding off again. Is there a cotter pin or something that should hold it in place?

That is what my fear is. I've tried resetting the modem and router. I think something happened to the coordinator. I'll call tech support on Monday morning.

I actually saw your issue when I searched. There was a long power outage several days ago. But it came back on and by now I would think it should have settled the transactions. When I check on the cryptopay site it shows the coordinator is offline. So, it is something related to the internet...

I noticed my tranaaxtion came to a squeching halt a few days ago. We've had some cold and rain so on a low volume car wash, it wasn't unexpected. But by the 3rd day I got suspicious. I ran my card through and after an abnormally long verification the bay started. But the transaction never...

I have two cameras per bay. One on the center of the entrance facing into the bay so I can get a rear license plate as the vehicle leaves. I have the second on the exit on the opposite corner of the coin box pointing toward the coin box which shows pretty much the entire bay and the coin box...

Yes, I'm flying out Thursday. I figured I would take an afternoon to goof off the a tax deductible trip.

Sure, I can meet you at the door. I'll likely have a grey polo that says 937Houses.com (my real estate company) on.

@UtahYoutubeGuy @swampdonkey and anyone else that will be in Vegas for the show next week, please message me your phone number so I can text you to discuss best day/time/location.

I thought Hash House was a breakfast place the last time I was in Vegas? Did you find a time, morning or evening, that worked better for people when you put it together?

That's a fair statement, but there are a lot of non-specific vendors there as well. There is no doubt it is now tunnel centric, but that just means the SS owners have to make more of an effort to find each other and network.

Who is going? I'd like to try to do a dinner meetup one evening. It's so hard to find other SS operators among the tunnel guys roaming the exhibits.

Thank you!

So, I blew a fuse in my weepmizer. Not a big deal. Expect when I went to put it back in it didn't get in all the way and the fuse holder seemed to just 'bounce' out and disappear. Does anyone happen to have a fuse holder I can buy or where can I get one?

My spot free has stopped working on 1 bay in my 4 bay wash. When I switch it on in the bay the gun does not spray water, there is no pressure. I've checked connections inside the meter box and they look and feel snug. I checked connection at the control panel in the mech room and it also looks...

I took the foot valve off and it did not appear clogged or broken, what causes them to go 'bad'? It looks like a pretty simple filter device.

Drilled a small hole on the hose that has the presoak mixed with water going into the tank. About an inch or so below the top of the holding tank.

Thanks Randy thst stopped the siphoning, but now the chemical is not flowing up. Could that be a bad foot valve?

I do have a foot valve.

My presoak is pulling water back into the Chem tube. We've taken it apart and cleaned everything but it is still backwashing. Tips,tricks or ideas?