Recent content by TMJ

That what I started trying to build, but ended up liking an angle better for my setup. If I couldn’t cut and weld it myself out of scrap I would buy those.

6-3/4”tall 2-7/8” 2 sides 2-1/4” other side

They are bolted, and the reason being the holes align with the screws for the swiper, so while it’s off you put a screwdriver through those holes to tighten the swiper down, then you bolt through those holes to the box with silicone and it’s water tight. I have vaults so putting in a bigger box...

My situation is pretty similar. 3 bay SS with old DS touchless, town of around 2k with traffic count of little less than 9k. But You’d have to drive 20-25 mins to get to any other wash. I do get some tourist traffic for the lake. Even with my traffic count on the worst month the bays will do...

Just wanted to share something I built so I could install Cryptopay on small coin boxes without having to buy new coin boxes. Have been on almost a year now without a single issue. Pics were shrunk so they’re small enough to upload. Can give more details if anyone interested.

Thanks for the reply. I have a couple Kip manifolds Ive had waiting to install. Hopefully I won’t regret the manifold.

Hoping I can get some advice on new to me pump stand I’m putting together. Original stand is rusted, messy wiring, motors need rewound and all pumps need rebuilt or replaced, it is also only single phase. Picked up an used stainless proline stand with Baldor 3 phase motor and installed new...