Greg, Thanks for your response. Yes, I located the exit eyes and one of them had fallen down in the can and was no longer communicating with the opposing eye. Appreciate your help.
Red light won’t reset after wash has finished - so checked on wash end of day today and noticed it was taking approximately three minutes or more for red light to reset after customer exited wash - I have checked treadle eyes and all is good - I am getting alarm 58 - customer waited longer than...
Okay - so checked on wash end of day today and notice it was taking approximately three minutes or more for red light to reset after customer exited wash - I have checked treadle eyes and all is good - I am getting alarm 58 - customer waited longer than 3 minutes to exit bay - have no clue what...
Yes it is on the roof - just old and rusting out - probably just going to need to get someone to build me a trough like the one that is there and replace - would just be nice to do away with but Mother Nature I assume says no to that - will wait for a few warm days and just get it done - thanks...
Has anyone tried to remove the old roof trough and replace with new. If so what material did you use and where do you get it.
I have even thought about not having a trough at all.
thoughts suggestions, thanks
I came in this afternoon and noticed oil in the floor so I looked up under the pump and oil appeared to be leaking between the pump and head. Is there a seal kit to fix this issue and it is possible to leak oil between head and pump on CAT3535
Thanks for the advice. I have a spare motor for the foam brush so I will swap it if I continue to experience the issue. First I am going to switch to a 15 amp slow blow fuse. I am currently using a 10 amp. “May be the problem but not sure” appreciate all the support as we all know it can be a...
I keep blowing my fuse for foam brush in the hand rack (power pack). Any suggestions?
I replace Fuse and foam brush works for a few days and then I get a complaint that it’s not working. Replace and works again. Have no clue what might be causing this.
phone - 469-247-1628
Robert Story
Need some help, phone number 469-247-1628 if you would like to cal.
Currently I am receiving alarm #25
- Top boom prox came on when boom was below the sensor head. Check for abnormality.
- I have replaced target ladder prox switches
Boom will go down about 19 to 24 inches and then machine...