Recent content by Ontario Car Wash

  1. O

    Kleen Rite Soaps

    Do you mix this with 10 gallons of water before you put it to the Hydrameter like kr concentrate or just run straight? Thanks
  2. O

    washworld high velocity gearbox oil

    I use a syringe and maybe add a little hose to it to get in the hole they couldn't've have put them in a worse place
  3. O

    Laser 4000 rollers

    Thank you I understand that my question is is that all the pieces there is to it the bearing then the cap a washer a lock washer and the screw? Just making sure I'm not missing a piece thank you
  4. O

    Laser 4000 rollers

    Time to change the rollers on this machine the other machine has rollers that have greaseable shafts this one has bearings is this all there is to it or is there something missing What I'm seeing is two bearings one on each side some sort of cap a washer a lock washer and a screw it's worked for...
  5. O

    4000 drifting

    THANKS FOR YOUR HELP Anyone travel to 44906 to replace a gear box im strapped for time be happy to pay someone to come change it out thanks
  6. O

    4000 drifting

    Thanks, tire pressure ok.. Think its gear box few weeks ago idiot with a truck and ladder rack got wedged in it almost tore the whole machine out of the ceiling. Its only locking in place when u push it towards the exit sometimes mostly if u put alot of pressure on it u can roll the...
  7. O

    4000 drifting

    Hello, My 4000 is drifting in the home position its sensing the front limit its lit on the gantry but its rolling past the flag sometimes which in turn activates the rear limit when it goes past frnt flag. Sometimes both rear and front are on if it catches them just right and then locks...
  8. O

    Starite pump low pressure

    Thank you everyone for the input. Ill take apart this weekend and keep ya posted. Also found an older thread with similar in the spot free section. Thanks again. Most likely swap out for a starite hp10e3112ma1 would this be sufficient ? I would assume it would at least be better thanks again
  9. O

    Starite pump low pressure

    I had a pump before at a location that you couldn't just hook up and turn on the only way I can get it to push at capacity was to turn the 1-in hose on turn the pump on and magically put them on together until it suck just right to prime itself otherwise it was kind of the same scenario it would...
  10. O

    Starite pump low pressure

    Shaving cream around fittings checking for air 😁
  11. O

    Starite pump low pressure

    I Bought the wash like this previous owners Over 30 years old all kinds of fun mods and handy man specials. No regulator it just turned on and would run around 40psi which was sufficient enough for a fan at bays obviously not the best pressure but no complaints I changed the solenoids u see...
  12. O

    Starite pump low pressure

    I think the pump is just shut got to be 10 years old I was there when I bought the car wash. Any suggestions on a new pump since I have to go buy one I'm assuming I should probably look for something that's about 200 PSI looks like this pump's running it to 220 and does not have a shut off...
  13. O

    Starite pump low pressure

    The big line feeds autoya I know it's not ideal. Solenoid is closed so no leak or sharingthanks
Top