Recent content by JAM

Utilities and everything else, building etc, is pretty cheap. Without paying ahead or investing towards it annually/above the monthly payment it works out to about the same scenario as you. I’ve taken almost all the profits of it so far and paid the mortgage down. How many CPY were you...

I’m all set on the size and other utilities. I’m at the point I need to either pull the trigger or keep it status quo. It will be a Razor XR-7 if I go this route. Smaller town/cold weather climate from December to April(busy season)- nearest wash is 10 miles down the road. I have the better...

I’m going through the process of looking at converting one of my SS bays to an IBA. Currently I have a 3 bay SS. For those of who have converted one of your bays to an IBA, what kind of decrease/increase in sales did you see on the SS side?

I ended up having too much weep water flow pressure. I adjusted using the needle valve to reduce the amount of water.

The weep is going into the inlet of the pump. All 3 of my pumps are set up like this one. Only this one is giving me issues for some reason. I was running a husky 307 air diaphragm pump recycling weep up until this year with no issues. Any reasons for someone plumbing the weep into the...

Hello- looking for a little help on this one as I can’t seem to pin point the issue. Short of replacing the entire pump. I have been trying to figure out what’s going on with one of my bays pulsation/hammering on start up. When starting the HP rinse the system will pulsate badly for 30-45...